Construction personnel in the fiber optic cable splicing, will inevitably encounter all sorts of problems need to solve, which requires staff to master the use of it skills, can effectively improve the work efficiency. Today, small make up for everybody introduction is on the thread when the welding technique, hope will be helpful to you.

Wiring project, the level of construction directly affects the performance of the system, serious be rework again, such as playing slot dialed the wrong number, the color scale on the distribution frame standard backwards and the wrong number, etc., including threading technology is relatively commonly used technology, will now this more mature experience to do a summary, for your reference.

Threading technology is a relatively common wiring technology, to ensure that the cable will not be broken resulting in the "short circuit", in all of the steel pipe mouth to plastic to protect the mouth was laid. A feasible method is thread personnel should carry when construction "mouth", when need can be placed at any time, in order to avoid because you don't have "protection" and "lazy". Vertical cable through the transition box walking into vertical steel pipe to the next layer, the transition to tie hanging in the box, avoid cable weight total pressure on the corner in the side of the cable, because it affects the transmission characteristics of cable. In the vertical line of cable tie hanging a per meter. Line groove cloth cable should be straight, no winding, and length.

Questions about the label, the cables shall be carried out in accordance with the floor plan of computer label, each label corresponding to a 4 to the conductor, the corresponding room and socket position cannot be mistaken, in the implementation, this is the place where the most error prone. Experience is that both ends of the label position from the end of the 25 cm, light color plastic adhesive tape, use oily pen write the label above sign or affix paper, and then wrap the scotch tape.

About more than "line" problem, cables in the distribution box more than "line" of the length to be consistent, and not too long. It is best to line grouped by grouped table, exported from slot straight tie is good, colligation point spacing is not more than 50 cm. It is important to note that unavailable or hard wire power cord tie.