Blow fiber optic cable machine can perform a reset properly, to set the interval to fiber appears on the screen but stop, stop in the "Settings" clearance and screen display.

The solution:

1 > press the "reset" button, make the system reset.

2 > open the wind cap, open left and right, respectively, pressure plate. Order the following check:

3 > check whether there is a broken fiber.

4 > check whether the optical fiber cutting length is too short.

5 > check match fibre channel and optical fiber. And carry on corresponding processing.

5. Optical fiber can perform normal reset, to set the interval to fiber continued backward movement, screen display "clearance" and "reshipment fiber".

The solution:

May be the microscope eyepiece dust deposition in the optical system caused by too much, stick with cotton to wipe the horizontal and vertical two road microscope eyepiece, observe with the eye has no obvious dust, then try again.